The case is solid, well made and goes together well. The method of attaching the top and bottom panels is unsatisfactory. You are required to attach the screw and nut to the panel loose, then slide the panel on with the nuts in the slots, then tighten fully. The included hex nuts are too loose in the slot. If you remove the screws to remove the top cover, you can't get the screws back in, because they are too short and the hex nut is very loose in the slot. It can be modified for low additional cost with four square M3 nuts and four M3x8mm machine screws, which helps. That way you can remove the top panel and reattach without needing to remove the back panel. The square nuts fit better in the top slot, still loose, but better, and the extra 3mm length in the screws can reach.